What does HV stand for?

Vickers Hardness

This definition appears very rarely and is found in the following Acronym Finder categories:

Science, medicine, engineering, etc.

Other Resources:

<< Previous	Abbreviation Database Surfer		Next >>
Hrvatska Vojska (Croatian Army) Hudson Valley Huis Visser Hunter Vehicle Hydrogen Vent Hydroxyvalerate (chemical compound) Hyper-Velocity Hypervisor Hyvä Veli (Finnish: Dear Brother) Transavia Airlines CV (code for Dutch airline)		High Voltage Insulated Gate Bipolar Transistor High Variation Mix High Voltage Subscriber Line Interface Circuit High Vacuum/Rapid Thermal Processing Chemical Vapor Deposition Hirudin Variant 1 Hypervariable Region 1 (forensic science) Hirudin Variant-2 Hirudin Variant 3 Halogenated Volatile Anesthetic Halton Voluntary Action (England, UK)

Samples in periodicals archive:

Indentation Size Effect in Vickers Hardness Testing of Ceramics.

Properties of TiN-matrix coating deposited by reactive HVOF spraying

[FIGURE 2 OMITTED] Creep measurements can be used to measure indentation hardness in terms of force/unit indentation in a manner similar to Tukon, Pfund, and Vickers hardness.

Coatings Clinic: thermal mechanical analysis

Hardness test Vickers micro indenter, having a square-based pyramidal-shaped diamond indenter with face angles of 136[degrees] was used to determine the Vickers hardness number (HV).

Mechanical and physical properties of slate from Britannia Cove, ...

The Rockwell hardness standard (E18) was published in 1932, followed by the Vickers and Knoop microhardness standard (E384) in 1969 and the heavy load Vickers hardness standard (E92) in 1952.

Tackling hard jobs: work underway to harmonize international hardness ...

The cracking behavior of the coatings under different indentation loads is investigated using a Vickers hardness tester.

Cracking analysis of HVOF coatings under Vickers indentation

The TMA can be used to measure indentation hardness in terms of force/unit indentation in a manner similar to Tukon, Pfund, and Vickers hardness.

Coatings clinic: introduction to thermal analysis

The method was developed primarily for metals and metal alloys, and, in the case of the Vickers hardness test, dead weight loading with a mass of from 1 kg up to tens of kilograms is applied onto a pyramidal indenter to produce indentations that can be measured easily using a light microscope.

Dynamic nanoindentation of some polyolefins

0008" thick and has a hardness of 3200 to 3800 on the Vickers hardness scale.

It keeps going and going