What does TM stand for?

Melt Temperature

This definition appears very rarely and is found in the following Acronym Finder categories:

Science, medicine, engineering, etc.

Other Resources:

<< Previous	Abbreviation Database Surfer		Next >>
Taal Lake Yacht Club (Philippines) Too Late, You're Dead (US Marine slang) Test Like You Fly (satellite testing procedure) Talleyman Tactical Landing Zone The Legendary ZeeBrothers (online gaming) The Loading Zone (various locations) Transfer on Less Than Zero (USN Rating) Torpedoman's Mate Linhas Aereas de Mocambique (Mozambique, IATA airline code)		Tactical Manager Tactical Missile Talent Management Tangmonkey.com Target Market target materials (US DoD) Target Missile Targeted Mutation Tarren Mill (World of Warcraft town) Task Master

Samples in periodicals archive:

For example, with 1000 lb/hr output and 470 F melt temperature processing HDPE: HP = 0.

How much horsepower do you need?

The foamability of linear and branched PP and the influence of injection molding parameters such as blowing agent concentration, shot size, back pressure, injection speed, and melt temperature on the resulting cell structure have been investigated by Guo et al.

The effect of injection molding conditions on the morphology of ...

9% Si will reduce a silica lining when melting at 2775F (1524C) because the melt temperature is above the equilibrium temperature of 2584F (1418C).

Understanding bottom wear in coreless induction furnaces

The higher the final recommended melt temperature for the resin, the higher zone 1 can be set.

Optimize barrel temperatures for barrier screws

[FIGURE 5 OMITTED] [FIGURE 6 OMITTED] Effect of Melt Temperature on Replication Figure 7 shows the influence of melt temperature on replication of micro scale v-groove for each material.

Effect of molecular weight and molding conditions on the replication ...

In mullite-based products, a reaction between the iron- or the manganese oxides and the silica portion of the mullite can occur, but will require a higher melt temperature to drive the reduction reaction.

Iron- and manganese oxides: culprits of refractory erosion

Moreover, the factors such as melt temperature and the cavity thickness on the effects of cavity roughness were not clarified.

Experimental investigation of key parameters on the effects of cavity ...

The center parts of the mold thereby receive a 10[degrees] higher melt temperature without increasing the maximum temperature or affecting the final mechanical properties.

New TPE & rubber presses optimize melt flow