This definition appears very rarely
and is found in the following Acronym Finder categories:
- Science, medicine, engineering, etc.
See other meanings of ITO
We have 96 other definitions for ITO
in our Acronym Attic
Samples in periodicals archive:
Current touchscreens use a transparent conductive film known as indium tin oxide (ITO), which is expensive and less effective on larger devices such as tablets.
Even the so-called organic devices such as OLEDs variously employ such materials as B, Al and Ti oxides and nitrides as barrier layers against water and oxygen, Al, Cu, Ag and indium tin oxide as conductors, Ca or Mg cathodes and CoFe nanodots, Ir and Eu in light emitting layers, for example.
Since its discovery, graphene has been seen as a potential replacement for indium tin oxide (ITO), the conductive material most commonly used in electronics, but advances in this direction have been hindered by the limited conductivity of the material.
The upper surface is made of indium tin oxide (ITO), which is both electrically conductive and partially transparent.
Nanoscale inorganic particles include indium tin oxide, silica, zirconium, corundum, aluminum hydroxide, zinc oxide, titanium dioxide, and carbon black; particle sizes range from 4 to 1000 nm.
As described in the American Institute of Physics journal Applied Physics Letters, nanoribbons such as these could one day replace indium tin oxide - an expensive material for which researchers have been searching for suitable substitutes.
2]-laser treatment was used to improve the electrical conductivity of coatings of indium tin oxide (ITO) nanoparticles on flexible polyethyleneterephthalate (PET) substrates.
Among their topics are the effect of water-soluble plasticizer on a barren raw material hard plastic extruding course, fabricating indium tin oxide targets by spark plasma sintering and hot-pressing sintering, synthesizing metastable tungsten carbide nanoparticles by a mechano-chemical alloying process, preparing boron nitride fibers by chemical reaction, sialite technology as a new process for the highly effective exploitation of industrial solid wastes, and the quasi-isenotropic compression characters of flier-plates with graded impedance.